Pipe Volume Pump

Pipe Volume Pump
Properties
Stacks	Yes (5)
Recipe
Created With	Hydraulic Pipe Bender, Fabricator
Cost	5g Iron, 2g Gold, 3g Copper
	v; t; e;

Description

Used to pump gasses throughout a pipe, featuring an adjustable valve 0-100 Liters and requiring power (2W per Liter). All the gasses in the pipes behind it will be completely pushed in front of it when powered, and blocks any flow of gasses in either direction when unpowered.

Note that valve settings are for the rate at which the pump operates, in volume per tick (0.5 seconds).

To calculate the moles per tick, use the following equation: n = (P * V) / (R * T)

Where:

P = Input pressure
V = The volume you set
n = Moles per tick
R = Gas constant (8.3144)
T = Input temperature (presumably in Kelvin)

Data Network Properties

These are all Data Network properties of this device.

Data Parameters

These are all parameters that can be written with a Logic Writer, Batch Writer, or Integrated Circuit (IC10).

Parameter Name	Data Type	Description
Lock	Boolean
Setting	Integer	Sets the flow rate between 0 - 100 Liters
On	Boolean

Data Outputs

These are all parameters, that can be read with a Logic Reader or a Slot Reader. The outputs are listed in the order a Logic Reader's "VAR" setting cycles through them.

Output Name	Data Type	Description
Maximum
Lock	Boolean
Error
Setting
RequiredPower
Ratio
PrefabHash
Power
On

</translate>